U2144 Engine Trouble Code
Meaning of U2144 engine trouble code is a kind of network trouble code and U2144 if your catalytic convertor fails completely, you eventually won't be able to keep the car running. Your gas mileage will also be terrible, so you should try and fix it as soon as you can. Unfortunately, the average replacement cost is around $2,140 and you can't do it yourself unless you're an experienced mechanic.
U2144 Fault Symptoms :
|
If one of these reasons for U2144 code is occuring now you should check U2144 repair processes.
Now don't ask yourself; What should you do with U2144 code ? The solution is here : |
U2144 Possible Solution:
Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged. |
U2144 Code Meaning :
U | 2 | 1 | 4 | 4 |
---|---|---|---|---|
OBD-II Diagnostic Network (U) Trouble Code For Engine | Fuel And Air Metering (Injector Circuit Malfunctions Only) | Fuel Rail/System Pressure - Too High | Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector) | Timing Reference High Resolution Signal A Too Many Pulses |
The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate.
U2144 OBD-II Diagnostic Network (U) Trouble Code DescriptionU2144 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.Main reason For U2144 CodeThe reason of U2144 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High. |
U2144 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.